The Radxa Single Board Computers (SBCs) are highly capable devices that offer significantly higher performance compared to the Raspberry Pi. Due to their impressive capabilities, we have incorporated support for Radxa SBCs in our 2.4-Evo releases and newer.
However, it's important to note that the software development for Radxa SBCs is currently in its early stages. We recommend using them primarily on the ground where hardware decoding support is only partially functional. Despite this limitation, the performance is still superior to that of the Raspberry Pi.
At present, there is only one camera available for Radxa SBCs, namely the IMX415, which may not meet the requirements of OpenHD. To address this limitation, we are actively collaborating with Arducam to develop and offer better camera options for Radxa SBCs.
For it there is a initial pipeline included, but it may not function well. We're also working on a HDMI pipeline and the integration for this. But keep in mind that only the Rock5B does have this functionality.
In the near future, we have plans to introduce support for the newest camera module from Arducam, the IMX462.
The following Radxa SBC models are currently supported:
SBCRadxa Rock5BThe following Radxa SBC models are currently being worked on:
SBCRadxa CM3Core3566**not technically radxa but we run radxa software on that board, it's also not the best working board, so it may take a lot of time until it is perfectly supported
Even 7 keys mapped to GPIO pins, only Right/Left/Up/Down needed for joystick navigation.